Zte’s interpretation of the hammer mobile aging test: can only use 10 times a day

on September 6, zte released a paper entitled “hammer T1 phone aging test report coarse solution” report, in view of the hammer on September 5, founder of science and technology the Smartisan T1 accelerated aging test report released.

zte said in the report, according to the standard gb and YD power and side keys for 50000 times, T1 report is 15000 times, if it is used for three years, can only use 10 times a day.

zte also said that in chemical experiment, general factory is to use alcohol or cosmetics, in the 35-45 degrees of environment preservation for 24 hours, and the hammer mobile phone just one hour in normal temperature preservation.

on September 5, Mr Luo released from foxconn langfang lab to issue the Smartisan T1 accelerated aging test introduction, the purpose may be to prove that the hammer to the quality of the mobile phone is good, but after zte coarse solution, but the results… Up to now, Mr Luo and hammer technology for zte’s report to respond.

the following is the hammer T1 phone aging test report coarse solution,

as standard text in the office, so some parameters can’t remember, only coarse solution.

a, standard basis, test report statement is based on MOTOROLA laboratory standard, so can’t with national standard or standard YD insist, just with the national standard, YD standard comparison and analysis.

two, falling standards. Report shows that use PVC drop, PVC is what I don’t say clear, gb and YD standard and most operators use is marble, concrete, steel, whose hardness is how, you see. Drop the key corners in the Angle of fall, this is wang freely highlight design flaws, will fall behind the screen from the Angle of crack.

three, button life, according to the standard gb and YD power and side keys for 50000 times, T1 report is 15000 times, which is used by a year, according to 40 times a day, according to three years to use, can only use 10 times a day, you want to use three years of classmate, are you ready for the bottom?

4, extrusion experiment, the standard requires 250 n, T1 report is 35 pounds of force, the equivalent of 155 n. Classmate, don’t into the pockets, pressure to be careful.

5, vibration test, the standard requires 10-500 hz, each 30 minutes, vibration parameters is the acceleration or power spectral density. T1 report is 30 hz, six sides, a total of 30 points, replace the acceleration or power spectrum with displacement parameters.

6, chemical experiment, general factory is to use alcohol or cosmetics, in the 35-45 degrees of environment preservation for 24 hours. T1 report just one hour in normal temperature preservation.

7, temperature test, high temperature and high humidity temperature index of the T1 many 45 degrees higher than standard, but the humidity and the test time is much lower than the standard. Hot and cold impact test temperature conversion speed is generally within 15 seconds, 10 minutes of T1 make impact effect.

You may also like...